Office · Beginner · 2–4 hours
Laptop Desk Riser
A desktop riser concept that lifts a laptop and creates a small storage bay underneath.
23 × 10 × 5 inPlanning reference
Planning reference: verify all dimensions, loads, fasteners, joinery and tool procedures for your actual materials and application before building.
Why build it
The compact size makes this a good project for learning clean cuts, edge treatment and simple ergonomic prototyping.
Materials
- 3/4 in plywood or solid board
- Wood glue
- Optional screws or dowels
- Non-slip feet
- Finish
Starter cut list
| Part | Qty | Length | Width |
|---|---|---|---|
| Top | 1 | 23 in | 10 in |
| Side | 2 | 4.25 in | 10 in |
| Optional rear stretcher | 1 | 21.5 in | 2 in |
Build sequence
- Prototype the target screen height with books or a cardboard mock-up.
- Cut the top and matched side pieces square.
- Dry-fit and verify enough clearance for the keyboard or accessories stored below.
- Join, sand and finish all touch surfaces smoothly.
- Use an external keyboard and pointing device if the laptop is raised beyond comfortable typing height.
Variations
| Variation | Width | Depth | Note |
|---|---|---|---|
| Travel size | 17 in | 9 in | For smaller laptops and limited desk depth. |
| Wide monitor stand | 32 in | 10 in | Wider surface for a monitor; verify stiffness and load. |
| Cable shelf | 23 in | 12 in | Adds depth for cable routing and a small device tray. |